PRESS F1 TO CONTINUE, CTRL-ALT-ESC OR DEL TO ENTER SETUP If you do not press the keys at the correct time and the system does not boot, an error message appears and you are again asked to You may also restart by simultaneously pressing Ctrl-Alt-Del. If the message disappears before you respond and you still wish to enter Setup, restart the system to try again by turning it OFF then ON or by pressing the RESET button on the system case. TO ENTER SETUP BEFORE BOOT PRESS CTRL-ALT-ESC OR DEL KEY By pressing Del or by pressing Ctrl-Alt-Esc when the following message appears briefly at the bottom of the screen during POST: By pressing Del immediately after switching the system on, orĢ. The BIOS launches the operating system and hands control of system operations to it.ĭuring POST, you can start the Setup program in one of two ways:ġ. When these preliminaries are finished, the BIOS seeks an operating system on one of the data storage devices (hard drive, floppy drive, etc.). The BIOS reads system configuration information in CMOS RAM and begins the process of checking out the system and configuring it through the power-on self test (POST). The Phoenix Technologies AwardBIOS is immediately activated when you first turn on the computer. The rest of this manual is intended to guide you through the process of configuring your system using Setup. The Phoenix Technologies AwardBIOS has been customized by adding important, but nonstandard, features such as virus and password protection, power management, and detailed fine-tuning of the chipset controlling the system. The BIOS provides critical low-level support for the system central processing, memory, and I/O subsystems. It supports Intel x86 and compatible processors. The Phoenix Technologies AwardBIOS in your computer is a customized version of an industrystandard BIOS for IBM PC AT-compatible personal computers. The settings are then stored in a dedicated battery-backed memory, called CMOS RAM, that retains the information when the power is turned off. The Setup program lets you modify basic system configuration settings. This concludes how to access the Boot Menu from a Phoenix Award BIOS and set your System to Boot with USB.This manual describes the Phoenix Technologies AwardBIOS Setup program. You can now proceed to boot Linux from your USB flash drive. If all went well, you should be presented with a boot screen containing your Live system. If you have properly formatted, activated the partition and installed Linux to your USB device, you can reboot.Note: If your USB device is not listed, you may need to set a boot flag on it to mark the partition active, so it can be detected as bootable. Use the up/down arrow keys to select your Bootable USB from the list, and then press enter.You should now see a menu similar to the one shown below. Use the up/down arrow keys to select the Hard Disk option from the menu and press Enter to accept.You should now be presented with a boot screen. Some commonly used BIOS Boot Menu keys are F2, F10, F11, and ESC Note: The key used to access your Boot Menu may vary. During the system post tap the F11 key (or the key your specific board manufacturer specifies) to get into Boot Menu.First insert a bootable USB flash drive into your computer, and reboot.How to Set Boot Menu to Boot from USBĪccessing the Boot Menu or Boot Manager on a Phoenix or Award BIOS to set a computer to Boot with USB. At that time, this system was easily able to boot from any properly setup bootable USB or external hard drive I have thrown at it. The system used for this demonstration featured an MSI K8N Neo4 (MS-7125) motherboard. Booting your computer from a USB flash drive instead of the internal hard drive. The following covers how to boot with USB. USB Boot Manager How to Access the Boot Menu on a Phoenix Award BIOS to select a USB flash drive as the first boot device.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |